9/19/2023 0 Comments Systemrescuecd uefi![]() It looks like the server is communicating ok. Quote from spollock on May 2, 2020, 4:40 pm SSH into CentOS 7 after installing it from the ISO and execute the following one at a time:ĭoes anyone have any ideas on how to get past this. We recommend having the main partition set to 16GB and leave the rest for the antlets zpool (which we’ll create with the edgeLinux installer) Note: Make sure that your root partition is not too big. Now I cannot get past the create swap file. Still the script failed at create swap file. So I reran the install script and this time it failed at create swap file, I assume because it was already created in the previous install that failed at antMan installation. ![]() This time I the templates added fine.I got all the way through to install antMan where it failed. The following commands are available: nmcli, ifconfig, ip, route, dhclient. You can also configure the network using traditional Linux commands from a terminal. The script failed at adding the templates (see image) so I started the installer again. Network tools You can configure the network (Ethernet or wifi) very easily using the Network-Manager icon located next to the clock at the bottom of the screen. I also rebooted after the yum install ansible wget simply because I wanted fresh before running the script again. this time I rebooted after the yum update even though it excluded the kernal updates. So I reinstalled CentOS7 minimal and started over. The install script FAILED on TASK which I attributed to faulty leftover partitions from the el-reset scripting. though I wondered if she meant reboot between them. I ran the steps one at a time as instructed. Installing CentOS7 minimal went well following the video referenced. Except the location to get the installation ISO is no longer valid. The first run of the process seemed promising. Quote from spollock on May 2, 2020, 11:56 amĪfter failure upon failure to reset my 3year old Antsle One using the OP same steps (from another thread) I found this thread which indicated to me that many folks were having trouble and that THIS is the new way to do it, though updating the original or other threads that the method was now outdated seemed like a positive step. Here are the instructions to install our new CentOS-based edgeLinux 2.0. Once you get it on a bootable USB stick then it should just take 15 minutes. We actually just switched over to edgeLinux 2.0, and while it's a fresh install, since you've already wiped your Antsle I think this would be the best place to start. Hey, sorry to hear you got stuck in the booting process. ![]() Let me know if you need any more help! Hopefully that does the trick. Step 3. Complete step three from the Antsle docs setup guide. Step 2. SSH into CentOS 7 after installing it from the ISO and execute the following one at a time: yum update -exclude=kernel* Note: Make sure that your root partition is not too big. Watch our video with instructions as you go through the installation: > See it here.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |